If you find that the tent is leaking, you can wipe the air column first and then apply the surface with soapy water to check for leaks. If the leak point is a small hole, you can use a small piece of circular repair cloth, and then brush the glue, after the glue is dry (important, must wait for the special glue to dry) attached to the leak point, the bond is tight . If the leak is the opening of the air column heat sealing joint, it can be processed in the following steps:
1. Clean the bonding surface first.
2, the inflatable tent will be given a bottle of glue, inflatable tent gas column special glue, brush it on the pre-adhesive surface, must be evenly painted, the thickness is appropriate, after brushing the picture two times, you can glue.
3, the shape of the adhesive interface must be designed to be circular or elliptical, try to avoid square and sharp angle interface shape, the overlap width should not be less than 30mm.
4. After the glue has evaporated, the bonding can be carried out. The patch must be flat, without wrinkles, rolled and smoothed, and the hair source is supplied with a hair dryer to facilitate bonding. After bonding for 6 hours, it can be inflated.
+86-0371-85956138 sites:
+86-0371-85956138
